System Performance Requirements
Drone Launch Vehicle
The erection capacity should comprehensively consider the total weight of the erection frame and the upper structure (≯5.5 tons).
Keyword:
erection
resistance
Category:
Other Custom Categories
Product Attachments:
E-mail :
Drone Launch Vehicle
Graphic Details
1. Preparation time: no more than 2 minutes (from parking completion to erection completion);
2. Retraction time: no more than 1 minute (from launch completion to start of withdrawal);
3. Wind resistance: should be able to launch normally under wind speeds not exceeding 12 m/s;
4. Rain resistance: should be able to operate normally under moderate rain conditions;
5. Sand resistance: able to operate normally in Gobi desert sand and dust environments;
6. Heat and humidity resistance: should be able to operate normally under conditions of temperature not less than 30°C and relative humidity not less than 95%;
7. Operating temperature: -20°C to +55°C;
8. Mean time between failures: not less than 5000 hours;
9. Reliability mileage with load: not less than 500 kilometers (including off-road mileage not less than 100 kilometers).
Erection System Requirements
1. The erection capacity should comprehensively consider the total weight of the erection frame and upper assembly (≤5.5 tons), and be designed with a certain safety margin;
2. Maximum erection angle ≥30°;
3. After erection, locking can be done at any position within the 20°~30° range, with a locking angle accuracy of 0.5°;
4. Erection operation must be interlocked with the marching lock status/operation;
5. When more than one erection actuator is used, their asynchronous characteristics must not increase the angular error of the target launch position on the loading platform;
6. Equipped with an emergency manual erection function;
7. Total time from system leveling start to launch box erection to the specified angle ≤2 minutes;
8. Time from leveling and erection system launch state to vehicle ready to start withdrawal ≤1 minute, allowing continued operation during movement (with leveling support off the ground) until fully retracted.
Marching Lock Requirements
Must withstand inertial loads during highway transportation:
1. Longitudinal (projectile axis) overload factor 3.5g;
2. Vertical overload factor 3g;
3. Lateral overload factor ±2g.
Must withstand shocks and vibrations during off-road transport and marching, with appropriate transport safety measures for vulnerable and easily loosened parts.
Previous Page
Next Page
Previous Page
Next Page
Leave a Message Consultation
If you are interested in our products, please leave your contact information, and we will contact you as soon as possible. Thank you!